Pazon Ignitions Limited
>> Products
>> Accessories
>> Voltage Regulators
>> Alternator Rectifier/Regulators
>> REGULATOR/RECTIFIER THREE-PHASE 12V
REGULATOR/RECTIFIER THREE-PHASE 12V
Rectifier/regulator for use with any three phase, three wire permanent magnet alternator, up to 200 watts, including Lucas RM24.
Simplify your wiring: replaces rectifier and zener diode(s) on British bikes (single/twins and triples).
Regulated output: 14.2 volts
Dimensions: 80mm x 80mm x 30mm deep
One year warranty.
SPECIFICATIONS:
Regulated output voltage: 14.2 Volts
Charging voltage: Dependent upon battery voltage and cable length to battery
Maximum power: 200 Watts in airflow (approx. 14 Amps @ 14.2V)
Wire lengths: 270mm from edge of casing
Mounting slots: 62mm between centres
Slot width: tapered 6.8mm (top) to 8.6mm (bottom)
CASE SIZE: 80mm x 80mm x 30mm deep
TOTAL WEIGHT (INC. WIRES): 300gms. (approx.)
FITTING INSTRUCTIONS:
Locate the unit close to the battery, if possible. Do not fit into a very confined space. Allow some air space around the unit for cooling, ideally in the airflow for high load systems.
Mount to the frame with two fixing bolts, nuts and washers. The case does not have to be earthed, therefore it can be rubber mounted or mounted onto a surface that is not grounded.
WIRING FUNCTIONS:
WARNING: DO NOT CONNECT THE BATTERY THE WRONG WAY AROUND
YELLOW WIRES: ALTERNATOR INPUT
BLACK WIRE: NEGATIVE OUTPUT
RED WIRE: POSITIVE OUTPUT
For example wiring diagrams, see datasheet (under Additional Links tab).
Regulated output voltage: 14.2 Volts
Charging voltage: Dependent upon battery voltage and cable length to battery
Maximum power: 200 Watts in airflow (approx. 14 Amps @ 14.2V)
Wire lengths: 270mm from edge of casing
Mounting slots: 62mm between centres
Slot width: tapered 6.8mm (top) to 8.6mm (bottom)
CASE SIZE: 80mm x 80mm x 30mm deep
TOTAL WEIGHT (INC. WIRES): 300gms. (approx.)
FITTING INSTRUCTIONS:
Locate the unit close to the battery, if possible. Do not fit into a very confined space. Allow some air space around the unit for cooling, ideally in the airflow for high load systems.
Mount to the frame with two fixing bolts, nuts and washers. The case does not have to be earthed, therefore it can be rubber mounted or mounted onto a surface that is not grounded.
WIRING FUNCTIONS:
WARNING: DO NOT CONNECT THE BATTERY THE WRONG WAY AROUND
YELLOW WIRES: ALTERNATOR INPUT
BLACK WIRE: NEGATIVE OUTPUT
RED WIRE: POSITIVE OUTPUT
For example wiring diagrams, see datasheet (under Additional Links tab).
- Installation Datasheet - Regulator/Rectifier Three-Phase 12
Volt| Product rating | |||
HOME
PRODUCTS
TECHNICAL HELP
WHAT YOU THINK
GALLERY
ARTICLES
DEALERS
ABOUT US
CONTACT US
LOGIN
PRODUCTS
TECHNICAL HELP
WHAT YOU THINK
GALLERY
ARTICLES
DEALERS
ABOUT US
CONTACT US
LOGIN
|
Free E-Book Click Here |
|
Copyright © 2005-2024 Pazon Ignitions Limited
