Pazon Ignitions Limited
>> Products
>> Accessories
>> Ignition Coils
>> Ignition Coil Pazon Dual Output 2ohm
Ignition Coil Pazon Dual Output 2ohm
6/12 Volt Dual Output Ignition Coil.
This coil must only be mounted by the two metal bar ends; this is the only way for heat to escape from the primary winding. Coils found to be overheated will not be covered by the warranty. An adequate heatsink should be provided, ideally using two aluminium spacers and a minimum of 80 square cms. of cold surface area. A good mounting to clean metal on the frame/chassis will normally suffice, but an extra aluminium heatsink is recommended, to allow the coil to work at its optimum, even at high temperatures and over extensive running periods.
Includes copper cored plug leads, length 75cm./29.5" and aluminium spacers, fixing bolts, nuts & washers.
Plug caps not included (available separately).
Applications:
- British Twin Cylinder motorcycles with 6 volt electrics and Sure-Fire/Altair electronic ignition system
- British Twin Cylinder motorcycles with twin-plug head conversion and 12 volt electrics plus Sure-Fire/Altair electronic ignition system. Two coils required.
- Twin cylinder machines fitted with a distributor and 6 volt electrics, including Triumph, Bsa, Norton, Sunbeam, Royal Enfield, AJS & Matchless. Converts to wasted spark ignition, eliminating troublesome distributor cap and rotor arm, boosting spark energy. Once fitted, better starting and reduced maintenance are the result.
- Japanese twin/four cylinder motorcycles with mounting hole centres @ 90mm or 102mm (note: two coils required for four cylinder motorcycles). Please check primary resistance requirements for your current ignition system. Two coils required for four cylinder engines.
This coil must only be mounted by the two metal bar ends; this is the only way for heat to escape from the primary winding. Coils found to be overheated will not be covered by the warranty. An adequate heatsink should be provided, ideally using two aluminium spacers and a minimum of 80 square cms. of cold surface area. A good mounting to clean metal on the frame/chassis will normally suffice, but an extra aluminium heatsink is recommended, to allow the coil to work at its optimum, even at high temperatures and over extensive running periods.
Electrical specification:
Primary resistance: 2.0 ohms (�10% @ 20� C.)
Secondary resistance: 13 Kohms (�10% @ 20� C.)
Output voltage: 29KV
Low tension connections: two ring terminals, screws & washers (supplied)
High tension leads: double insulated copper cored leads (7mm)
Plug (H.T.) lead length: 75cm/29.5" (approx.)
Dimensions:
Mounting centres: 6.5mm @ 90mm & 102mm
Body dimensions: 49mm wide x 52mm deep (approx.)
Overall length: 102mm
Weight: 365g (approx.), without plug leads
| Product rating | |||
HOME
PRODUCTS
TECHNICAL HELP
WHAT YOU THINK
GALLERY
ARTICLES
DEALERS
ABOUT US
CONTACT US
LOGIN
PRODUCTS
TECHNICAL HELP
WHAT YOU THINK
GALLERY
ARTICLES
DEALERS
ABOUT US
CONTACT US
LOGIN
|
Free E-Book Click Here |
|
Copyright © 2005-2024 Pazon Ignitions Limited
